Do it yourself
Frequently asked questions about cars and motorcycles
To replace the coolant on an Aprilia Shiver 750, first remove the right side panel by loosening all the bolts with an Allen key. Use a screwdriver to loosen the clamp on the lower hose, allowing all the coolant to drain out. Then disconnect the hose from the pump and let all the coolant flow into a bucket. To ensure all the water drains from the pump, you may need to tilt the bike and close off any other possible outlets. Once all the liquid is removed, reconnect the hose and pour in the new coolant to ensure it circulates.

Updated on 19 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Shiver 750 To replace the coolant in the Aprilia Shiver 750, position a container under the drain hose to collect the old fluid. The hose must be disconnected f…
Shiver 750 In this short and simple guide, follow the steps to replace the coolant in the Aprilia Shiver 750. First, place the bike on its stand and start remov…
Shiver 750 You can replace the rear brake pads on the Aprilia Shiver 750 by removing the safety clip and unscrewing the pin that holds the pads in place. It is …

How to Replace the Tyres on the Husaberg FE 450

In this guide, follow the instructions to remove and replace the tyres on the Husaberg FE 450 enduro bike. First, place the bike on a stand and lift the wheel off the ground; then, undo the bolts securing the brake caliper to remove it, as shown in the video. Next, unscrew the central axle of the wheel, removing the tyre from the rim (deflating it and using levers); then install the new tyre, ensuring it has the correct dimensions, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos