|
Do it yourself
| |||
| ||||
How to replace the belt on the Aprilia SR 50?
Model: Aprilia Sr 50
Video tutorial
To replace the belt on the Aprilia SR 50, first loosen all the screws securing the cover of the casing near the rear wheel. Once the casing is open, you will need to loosen the nut that secures the variator to its central shaft. After removing the variator, perform the same operation to remove the clutch bell and then the clutch itself. Once the clutch and variator are removed, you can slide out the belt and replace it with a new one, which should be reinserted around the clutch and variator.
Updated on 25 April 2026 by ScegliAuto
Related tutorials
Sr 50
This guide outlines the steps to remove and replace the variator on the Aprilia SR 50 scooter, following the instructions below. First, place the cen…
Sr 50
In order to replace the transmission of the Aprilia SR 50, you need to loosen the screws that fix the casing to its housing, near the rear wheel on t…
Sr 50
To replace the transmission of the Aprilia SR 50, you need to loosen the screws that secure the cover located at the rear wheel, on the left side of …
|
How to Replace the Coolant in the KTM XC 300
Follow this guide on how to replace the coolant in the KTM XC 300 enduro bike, as well as the XC-W 300. First, place your bike on a stand and start by unscrewing the coolant drain screw located at the bottom of the water pump casing, allowing it to drain into a container for about ten minutes; then unscrew the radiator cap as shown in the video. At this point, top up with new coolant suitable for your radiator, filling to the maximum level mark! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.007
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |