Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Light Bulbs on an Aprilia Scarabeo 125 Scooter

Model: Aprilia Scarabeo 125
Part: Headlight bulb

Video tutorial

In this tutorial, you will see how to replace the rear light bulbs on an Aprilia Scarabeo 125 scooter, a very simple and quick operation. To do this, you will only need a cross-head screwdriver.

First, ensure that the key is not inserted. Then, unscrew the two screws located at the back of the light, remove it, and disconnect the power connector.

Once this is done, grasp the bulb holder of the bulb to be replaced, turn it counterclockwise, and remove it from the housing. Finally, insert the replacement bulb, avoiding direct contact with the glass using bare hands.


Updated on 15 July 2026 by ScegliAuto


Related tutorials

How to reset the service light on the Aprilia Scarabeo 125
How to reset the service light on the Aprilia Scarabeo 125
Scarabeo 125 If the service light on your Aprilia Scarabeo 125 comes on despite having already performed the service, you need to follow this manual reset procedu…
How to Replace the Starter Motor on an Aprilia Scarabeo
How to Replace the Starter Motor on an Aprilia Scarabeo
Scarabeo 125 To replace the starter motor on an Aprilia Scarabeo, loosen the screws that secure the motor to its housing: this will be accessible from the left si…
How to Replace the Front Indicator Bulb on an Aprilia Scarabeo
How to Replace the Front Indicator Bulb on an Aprilia Scarabeo
Scarabeo 125 To replace the indicator bulb on your Aprilia Scarabeo, loosen the screws securing the front fairing of the bike: these are located just below the ha…

How to Replace the Coolant in the KTM XC 300

Follow this guide on how to replace the coolant in the KTM XC 300 enduro bike, as well as the XC-W 300. First, place your bike on a stand and start by unscrewing the coolant drain screw located at the bottom of the water pump casing, allowing it to drain into a container for about ten minutes; then unscrew the radiator cap as shown in the video. At this point, top up with new coolant suitable for your radiator, filling to the maximum level mark!

Watch the video!


by ScegliAuto

More videos