Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Disassembly of the rear windshield wiper motor of the Audi A4.

Model: Audi A4 B8 - Years 2007-2016

The steps illustrated in this guide will show us how to disassemble and replace the rear windshield wiper motor or rear wiper of the Audi A4. First, we will disassemble and remove the rear windshield wiper; then we open the trunk door and remove the inner plastic panel, as shown in the video. At this point, we unscrew the fixing screws of the windshield wiper motor, then disconnect the electrical connector to remove it and replace it with the new one; we reassemble the new replacement and finally the rear trunk panel, checking the operation of the rear wiper!

Posted on 31 October 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Install the Rear Wiper Motor on Audi A4 B7
How to Install the Rear Wiper Motor on Audi A4 B7
Audi A4 (2004-2008 / B7) In today's video, you will learn how to install the rear wiper motor on an Audi A4 B7. First, position the new wiper motor on the trunk lid, where th…
Replacement of the rear windshield wiper motor of the Audi A4
Replacement of the rear windshield wiper motor of the Audi A4
Audi A4 (2004-2008 / B7) In this short guide, we will see the instructions that will allow us to disassemble and replace the rear windshield wiper motor of the Audi A4. First…
How to Remove the Rear Wiper Motor from the Audi A4 B8
How to Remove the Rear Wiper Motor from the Audi A4 B8
Audi A4 (2007-2016 / B8) This guide shows how to remove the rear wiper motor from the Audi A4 B8. After removing the courtesy light and the screws securing the trunk door pan…

    Frequently Asked Questions

    • A4 2004-2008 - How much does it cost to change ownership of an Audi A4 1.9 TDI? Read answer

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos