Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to mount the front bumper with honeycomb grille on the Audi A4 B9

Model: Audi A4 B9 - Years 2014-2024
Part: Front bumper

In this video we can see how to disassemble the front bumper of the Audi A4 and replace it with the RS honeycomb one. We remove the clip in the center of the plastic trim, then the screws holding the bumper on the front, and remove the screws inside the fender. After this we can remove the bumper from its housing. Once removed, we can remove the visible screws from the inside and then the clips, in order to remove the grille. We put the RS grille in its place. We can find it for example on Autorivallo. Com, at a price of 399.00 euros. We reassemble the grille on the bumper by inserting the clips and then screwing the screws. We reassemble the bumper following the reverse sequence, and the job is done.

Posted on 19 February 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Install a Front Bumper on an Audi A4
How to Install a Front Bumper on an Audi A4
Audi A4 (2007-2016 / B8) How to install a front bumper on an Audi A4? Follow these steps for a straightforward process. First, grab the bumper and position it perfectly again…
How to Remove the Rear Bumper of an Audi A4
How to Remove the Rear Bumper of an Audi A4
Audi A4 (2004-2008 / B7) How to remove the rear bumper of an Audi A4? Follow these steps to proceed, a task that is not too complex if done in order: First, use a screwdriver…
How to Remove the Front Bumper on Audi A4
How to Remove the Front Bumper on Audi A4
Audi A4 (2004-2008 / B7) Want to replace the grille or bumper on your Audi A4? Here’s how to remove the front bumper. Lift the hood and secure it, then raise the car on a jac…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos