Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Light of the Audi A3

Model: Audi A3 8V, MK 3 - Years 2012-2019
Part: Tail light

Today, you will learn how to remove the rear light from an Audi A3. To perform the removal, you will need a flathead screwdriver and a 10mm Torx key. Open the boot and using the flathead screwdriver, remove the internal cover of the light. After removing the cover, unscrew the nuts with the Torx key. Remove the light from its housing, disconnect the connector to extract it, and proceed with any bulb replacement. Follow the same steps for removing the left rear light. The installation of the rear lights follows the reverse procedure.

Posted on 3 February 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Removing the Rear Stop Light on Audi A3
Removing the Rear Stop Light on Audi A3
Audi A3 (1996-2003 / MK 1, 8L) This guide covers the removal of the rear light on an Audi A3. Remove the various covers to access the rear light. Lift the boot, open the plastic in…
How to disassemble the rear headlight of an Audi A3?
How to disassemble the rear headlight of an Audi A3?
Audi A3 (2003-2013 / MK 2, 8P) To disassemble the rear light of an Audi A3, follow these steps. Start by opening the trunk door to access the light, then remove the internal side c…
How to Remove the Rear Light of an Audi A3
How to Remove the Rear Light of an Audi A3
Audi A3 (2012-2019 / 8V, MK 3) To remove the rear light of an Audi A3 model 8V, follow these steps: - open the boot; - remove the side cover; - unscrew the two Torx screws; - pull …

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos