Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to remove the Audi Q5 8R front passenger door panel

Model: Audi Q5 MK 1, 8R - Years 2008-2017
Part: Door trim panel

The guide shows how to remove the interior panel of the front right door of the Audi Q5 8R. Remove the door finishing panel with a plastic lever. Below this element there are two Torx T25 screws to be unscrewed. Two more Torx screws are located under the door handle and on the bottom of the door panel. Lift the lower part of the panel with the plastic lever and climb on the edges. At this point it is possible to remove the panel and disconnect the electrical connectors and the door cable. Be careful at this stage to avoid damaging the cables.

Posted on 8 November 2021 by ScegliAuto

Video tutorial

Related tutorials

Disassembly of the front headlight of the Audi Q5
Disassembly of the front headlight of the Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) The instructions provided in this guide will explain the process of disassembling and replacing the front headlight of the Audi Q5. First, we open th…
Replacement of the timing belt of the Audi Q5 2.0 TDI
Replacement of the timing belt of the Audi Q5 2.0 TDI
Audi Q5 (2017-2025 / 80A, MK 2) Let's find out in this guide the main steps that will allow us to remove and replace the timing belt of the Audi Q5 2.0 TDI. First of all we open the…
How to disassemble the headrests of the Audi Q5
How to disassemble the headrests of the Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) Following the instructions in this guide, we will see how to disassemble and remove the front headrests, but it also applies to the rear headrests, o…

How to Install Roof Bars on a Fiat 500X

Learn how to equip your car with universal roof bars. Universal roof bars are used on cars with and without roof rails (fixed bars secured to the car roof). Install the roof bar kit as shown in the video with the bars calibrated according to the width of the car. Position the brackets at both ends of the doors on the car's original roof rails. Once the width of the anchoring brackets is adjusted, tighten the bolts with the butterfly nut (if a lock is present) until fully secured to the roof rails. Finally, apply the safety caps on your Fiat.

Watch the video!


by ScegliAuto

More videos