Do it yourself
| ||||
|
Audi A3 - Video tutorial
Model: Audi A3
MK 2, 8P
- Years 2003-2013 The following operation must be done by lifting the car and in total safety since a lot of force is required to disassemble the hub. You find that you need to replace the wheel bearing due to the constant noise it starts making when it stops working properly. To carry out this operation, it is necessary to remove: the wheel, the brake pads and discs, the hub protection cup and the hub-bearing unit. Before reassembling everything, the surfaces of the various parts, the pin, the upright and the point where the hub will hit must be thoroughly cleaned. The new bearing must be pushed on the pin evenly, taking care not to disassemble it from the hub.
Posted on 24 July 2023 by ScegliAuto
Other guides that may interest you
|
How to reset the TPMS light of the Volkswagen Polo 2011The orange tire light indicates the presence of one or more tires with an inflation pressure below the recommended limit. All this is easily solved by inflating them correctly or replacing them in the event of a puncture. After carrying out these operations it is necessary to reset the warning light and therefore also the sensor in order to have new reading data. All you have to do is start the car ignition and then fully open the glove compartment on the passenger side. Locate the two buttons in the right corner and press "Set". At this point the reset is complete and you can turn off the ignition. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.028
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |