Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the timing belt on the Audi Q3?

Model: Audi Q3 8U - Years 2011-2018
Part: Timing belt

In order to replace the timing belt of the Audi Q3 you have to go to the lower part of the car, removing the protective panel of the lower part of the engine compartment. Once this panel has been removed, it will be possible to access the pulleys, which must be loosened by reducing the tension of the belt; subsequently accessing from the upper part of the engine block, it will be possible to remove the belt so that it can be replaced with a new spare part. After installation, the pulleys can be attached and the lower engine compartment panel mounted.

Posted on 28 March 2022 by ScegliAuto

Video tutorial

Related tutorials

Guide to Replacing the Timing Belt on the Audi Q3 2.0 TDI
Guide to Replacing the Timing Belt on the Audi Q3 2.0 TDI
Audi Q3 (2011-2018 / 8U) Below are the main instructions that will guide you on how to remove and replace the timing belt on the Audi Q3 2.0 TDI. First, open the hood and sta…
Replacement of the timing belt of the Audi Q3 2.0 TDI.
Replacement of the timing belt of the Audi Q3 2.0 TDI.
Audi Q3 (2011-2018 / 8U) Through these short and simple steps, we will see how to disassemble and replace the timing belt of the Audi Q3. First, lift the vehicle and start by…
How do you replace the timing belt of the Audi Q3?
How do you replace the timing belt of the Audi Q3?
Audi Q3 (2011-2018 / 8U) To replace the timing belt of the Audi Q3, you need to open the hood so that you have access to the components located inside the engine compartment.…

Other guides you may be interested in

How to Change the Diesel Filter on a Renault Captur 1.5 dCi

The diesel filter on the Renault Captur is always of the immersion type, but instead of being located at the top of the engine bay, it is positioned lower, inside the front right wheel arch (passenger side), practically under the headlamp. To replace it, it is advisable to lift the vehicle, remove the front right wheel and the corresponding inner lining to access the filter location. Unscrew the fastening nuts of the support clamp to extract it from its housing and disconnect the connector and pipes. At this point, unscrew the fixing screws of the cap, remove the old filter and insert the new one, also replacing the O-ring seals, and then reverse the steps for installation. Before starting the engine, turn the ignition on and off several times to allow the filter to fill.

Watch the video!


by ScegliAuto

More videos