Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Timing Belt on the Audi Q3 2.0 TDI

Model: Audi Q3 8U - Years: 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018
Part: Timing belt

See other generations:
Video tutorial

Follow these simple steps to remove and replace the timing belt on the Audi Q3. First, lift the vehicle and remove the right front wheel and the wheel well; then disconnect the alternator belt and remove the bolts from the crankshaft pulley to take it off, as shown in the video.

Next, remove the timing cover, pressing the necessary references for the timing belt replacement; install the new original belt, following the video tutorial to the end!


Updated on 16 August 2026 by ScegliAuto


Related tutorials

Guide to Replacing the Timing Belt on the Audi Q3 2.0 TDI
Guide to Replacing the Timing Belt on the Audi Q3 2.0 TDI
Audi Q3 (2011-2018 / 8U) Below are the main instructions that will guide you on how to remove and replace the timing belt on the Audi Q3 2.0 TDI. First, open the hood and sta…
How to Replace the Timing Belt on an Audi Q3
How to Replace the Timing Belt on an Audi Q3
Audi Q3 (2011-2018 / 8U) To replace the timing belt on an Audi Q3, access the underside of the vehicle by removing the lower engine cover panel. Once the panel is removed, yo…
How to Replace the Timing Belt on an Audi Q3?
How to Replace the Timing Belt on an Audi Q3?
Audi Q3 (2011-2018 / 8U) To replace the timing belt on an Audi Q3, open the hood to access the components in the engine compartment. On the left side of the engine block, you…

Other guides you may be interested in

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos