Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Spark Plug Leads

Model: Audi A3 MK 2, 8P - Years 2003-2013
Part: Spark plugs

The following images examine a problem related to irregular combustion. In this specific case, after removing the engine cover and the intake manifold, it was noted that one of the spark plugs was not properly tightened, and exhaust gases were partially escaping from the spark plug seat, which has become discoloured. Irregular combustion can also be caused by the spark plug leads. When replacing them, it is advisable to remove one lead at a time and replace it with a new one, avoiding disconnecting them all at once. Note the different lengths of each lead depending on the spark plug it connects to. Car model: Audi A3

Updated on 11 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the Audi A3's spark plugs?
How do you replace the Audi A3's spark plugs?
Audi A3 (2003-2013 / MK 2, 8P) In order to replace the spark plugs of the Audi A3, you need to open the hood so that the plastic cover on the top of the engine block can be removed…
Replace the Cylinder Head Gasket
Replace the Cylinder Head Gasket
Audi A3 (2003-2013 / MK 2, 8P) The gasket is a component that sits between the cylinders and the cylinder head, ensuring that oil and coolant do not come into contact or leak. The …
How to change the car radio in the Audi A3?
How to change the car radio in the Audi A3?
Audi A3 (2012-2019 / 8V, MK 3) To make this replacement we must equip ourselves with the special pliers to extract the car radio. These are sold in sets of 4 to a few euros and are…

Other guides you may be interested in

How to Replace the Front Headlamp Bulb on a Fiat Grande Punto

To replace the front headlamp bulb on a Fiat Grande Punto, first open the bonnet. Once done, access the rear of the headlamp where the bulb needs replacing (the bulb is of type H4). Locate the rubber cover that protects the electrical contacts and bulbs from water and moisture. Remove it by pulling on the tab. Now, pull the connector for the bulb's power supply and disconnect it from its position. At this point, push down on the top of the spring that holds the bulb in place, and you can extract the bulb from its housing. To fit the new bulb, follow the steps in reverse as shown in the images. The video also shows how to remove the position bulb, which is located just below the H4. After disconnecting the power supply, you can extract it along with the bulb holder by pressing the two tabs to release it and pulling. The bulb can then be removed from its position in the bulb holder.

Watch the video!


by ScegliAuto

More videos