Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to remove the rear light of the Audi A4 B6.

Model: Audi A4 B6 - Years 2000-2004
Part: Tail light

In the following guide, we will discover together how to correctly disassemble the rear light of your Audi A4 B6. First of all, you must turn off the car and park it on a flat surface so that you can perform the entire procedure safely. Then go to the rear of the car and lift the trunk completely. Locate a fabric cap located in the area adjacent to the light to be removed and remove it. At this point, unscrew the screws present and then move outside to gently pull the rear light. Disconnect it from the electrical pin and you're done.

Posted on 7 June 2023 by ScegliAuto

Video tutorial

Related tutorials

How to replace the third brake light on the Audi A4
How to replace the third brake light on the Audi A4
Audi A4 (2000-2004 / B6) Today's steps will show us how to disassemble and replace the third brake light on the Audi A4. First, we open the rear trunk door and start removing…
Removal of the rear light on the Audi A4
Removal of the rear light on the Audi A4
Audi A4 (2007-2016 / B8) Do we want to remove the rear light of our Audi A4? Let's see how to remove the rear light from inside the car tailgate. We open the luggage compartm…
How to remove the headlight of an Audi A4
How to remove the headlight of an Audi A4
Audi A4 (2004-2008 / B7) Before we can begin, we will have to go and open the front hood of our Audi A4. So let's start by unscrewing and removing the screws that secure the …

Removing and Replacing a Front Headlamp of a Lancia Lybra

This video explains how to remove and replace the front headlamp and its bulbs on a Lancia Lybra. The car has a very simple and quick headlamp removal system. To start, lift the bonnet, reach into the engine bay, and (specifically at the rear of the headlamp) unclip the metal tab that secures the headlamp, then use a screwdriver to undo the few Torx screws. After removing the screws, unclip the headlamp and pull it out from the bumper, disconnect the power connectors, and replace any damaged bulbs or the entire unit. The reassembly phase is very straightforward: insert the headlamp into the bumper housing as shown in the video, secure the metal tab until the headlamp clicks into place (screw in the securing screws). Finally, test the correct operation of the lights.

Watch the video!


by ScegliAuto

More videos