Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to Removing the Front Seat of the Audi Q5

Model: Audi Q5 MK 1, 8R - Years 2008-2017
Part: Seat

Today's main instructions will show you how to remove and replace the front seat of the Audi Q5 in simple steps. First, open the front door and start unscrewing all the mounting screws you find on the front seat tracks, moving the seat back and forth to access them. Then, disconnect all the electrical connections located underneath, as shown in the video. At this point, perform the repair or cleaning of the seat, replacing it if necessary. Follow the procedure for reassembly, adjusting the position at the end!

Updated on 8 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Brake Pads on an Audi Q5
How to Replace the Front Brake Pads on an Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) In this guide, we will outline the steps to remove and replace the front brake pads on an Audi Q5 in simple steps. First, lift the vehicle and begin …
Guide to Removing the Timing Belt on the Audi Q5 2.0 TDI
Guide to Removing the Timing Belt on the Audi Q5 2.0 TDI
Audi Q5 (2008-2017 / MK 1, 8R) In this guide, you will see the steps and procedure to replace the timing belt on the Audi Q5 2.0 TDI. For this engine type, the timing belt replacem…
How to Remove the Rear Seats of the Audi Q5
How to Remove the Rear Seats of the Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) Today's guide will show you the steps to remove the rear seats of the Audi Q5, following the instructions below. First, open the rear doors and start…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos