Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Where is the OBD port located on the 2010 Audi Q5?

Model: Audi Q5 MK 1, 8R - Years 2008-2017
Part: Dashboard

If you still don't know where the OBD port is located inside your first-generation Audi Q5 (2010), don't worry because in the following guide we will give you all the necessary directions. First of all, enter the passenger compartment and make sure the car is completely turned off, then reach the driver's seat and shift your attention to the lower area of the dashboard. At this point, locate the OBD port on the left side and you're done. To use it, simply connect any diagnostic tool with a specific cable to it.

Posted on 5 June 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Airbag Light on an Audi Q5?
How to Reset the Airbag Light on an Audi Q5?
Audi Q5 (2008-2017 / MK 1, 8R) When the airbag light illuminates on the Audi Q5 display, it indicates a generic malfunction in the system. To identify the source of the problem and…
What does the message "Engine on, turn off" indicate in the Audi Q5?
What does the message "Engine on, turn off" indicate in the Audi Q5?
Audi Q5 (2017-2025 / MK 2, 80A) The electronic options stored in the Audi Q5's control unit, aimed at safeguarding all possible safety criteria, are numerous, and among these we fin…
How to disable the AdBlue refill warning on the Audi Q5
How to disable the AdBlue refill warning on the Audi Q5
Audi Q5 (2017-2025 / MK 2, 80A) The main instructions in this guide will show us how to reset the AdBlue fluid refill warning on the Audi Q5. First, we get inside the vehicle and st…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos