Do it yourself
Frequently asked questions about cars and motorcycles

Model: Beta Rr 200

In this guide, we will go through the instructions that will allow us to disassemble and replace the oil seal of the secondary shaft of the Beta RR 200 enduro motorcycle. First, we place the motorcycle on a stand and begin removing the sprocket cover, thus accessing the secondary shaft; then, we use a lever to extract the oil seal from the bearing, as shown in the video. At this point, we correctly install the new original oil seal until it is properly seated; we then proceed to reassemble the cover, reinstalling or adjusting the drive chain if necessary.

Posted on 30 November 2025 by ScegliAuto

Video tutorial

Related tutorials

Rr 200 In order to remove the oil pump of the Beta RR 200, you need to remove the side panels located at the front of the motorcycle, immediately below the …
Rr 200 To replace the clutch on the Beta RR 200, loosen the screws securing the cover of the casing, located on the lower central part of the right side of …
Rr 200 In this video, we will show you how to perform the routine maintenance service by changing the oil on a Beta RR 200 motorcycle. First, remove the pro…

How to Replace the Windscreen on a BMW K1600?

To replace the windscreen on a BMW K1600, you need to loosen the screws that secure it to its housing: there are six screws located at the lower sides of the windscreen, corresponding to the two supports present. Once all screws are loosened, you can completely detach the old windscreen from its housing, allowing you to insert the new one. The new windscreen can now be secured with the appropriate screws, ensuring it is installed correctly and does not cause issues while riding.

Watch the video!


by ScegliAuto

More videos