Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Tank on Beta RR-S 500?

Model: Beta Rr S 500
Part: Checks and maintenance

Video tutorial

To replace the tank on the Beta RR-S 500, you need to loosen the bolts securing the side panels of the bike, located on the front side parts. Once these are loosened, you can remove the side panels to access the tank underneath.

The tank must be freed from its position by unscrewing the screws and disconnecting the hoses and connectors, allowing it to be completely removed. After removing the old tank, you can install the new one, which should be connected and secured properly, covering it with the side panels.


Updated on 24 May 2026 by ScegliAuto


Related tutorials

Replacing the Coolant in the Beta 500 RR-S
Replacing the Coolant in the Beta 500 RR-S
Rr S 500 .. the old coolant or antifreeze in the Beta RR-S 500 enduro motorcycle. First, unscrew the drain screw for the coolant, located on the casing of the.. …
Engine Oil Change for the Beta RR-S 500
Rr S 500 .. the engine oil and oil filter on the Beta RR-S 500 enduro bike. First, warm up the engine for a few minutes and remove the oil drain bolt located.. …
How to remove the stator from the Beta RR-S 500
How to remove the stator from the Beta RR-S 500
Rr S 500 ..n how to remove the stator from the Beta RR-S 500 enduro bike by following these simple and quick steps. First, place your bike on a stand and start b.. …

How to remove the panels of the Peugeot Kisbee

In this short and simple guide, you will see how to remove the plastic panels of the Peugeot Kisbee scooter, following the instructions provided below. First, place your scooter on the centre stand and begin by lifting the rider's seat; then, unscrew the fixing screws found in the under-seat compartment and under the footboard, subsequently removing the panels as shown in the video. At this point, unscrew the screws of the footboard to remove it, then remove the front shield (disconnecting the electrical connectors as well); finally, reassemble everything by applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos