Do it yourself
Frequently asked questions about cars and motorcycles
This brief guide explains how to reset the fault or service warning light on the Beta RR 200 enduro bike, as well as the RR 300. First, place the bike on its stand and remove the rider's seat by disconnecting the two electrical connectors next to the foam air filter; then remove the front headlight assembly and disconnect the main wiring for the bulbs, as shown in the video. At this point, also disconnect the display wiring by pressing the indicated connector with a sharp object to complete the reset!

Updated on 10 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Rr 200 It will be possible to replace the rear turn signal bulb of the Beta RR 200 by loosening the screws that secure the corresponding light located on th…
Rr 200 In this video, we will show you how to perform the routine maintenance service by changing the oil on a Beta RR 200 motorcycle. First, remove the pro…
Rr 200 In order to remove the oil pump of the Beta RR 200, you need to remove the side panels located at the front of the motorcycle, immediately below the …

How to Replace the Throttle Valve on the GasGas EC 300?

To replace the throttle valve on the GasGas EC 300, remove the entire throttle body from its housing. This is connected between the cylinder and the intake manifold. Once the throttle body is removed by loosening the screws and disconnecting all connectors, proceed to detach the connectors attached to it. Then, the valve can be removed from inside the throttle body and the new one can be inserted. Finally, reassemble everything and check its operation.

Watch the video!


by ScegliAuto

More videos