Do it yourself
Frequently asked questions about cars and motorcycles

Installing LED Ring for Angel Eyes Effect

Model: BMW Serie 3 E46 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Headlight bulb

See other generations:
This video is currently unavailable

Open the front hood and ensure it is securely supported. Detach the side turn signal by loosening the mounting screw (access hole on the inner edge of the fender).

Remove the trim-seal on the headlight by lifting the triangular retaining tabs. Detach the lower cover located just below the headlight.

At this point, you can remove the headlight cover glass by disengaging the retaining tabs and extract the inner plastic frame. Then, attach the retaining clips (clip fasteners) behind the LED ring, route the wires over the reflector, and attach the LED ring to the edge of the reflector (if necessary, slightly open the clip fastener with a small screwdriver).

Repeat the operation on the other reflector and connect the wires to the control unit wiring. Proceed with reassembly by first inserting the inner plastic frame; reattach the headlight glass (it is suggested to clean the inside carefully); reposition the lower cover, the upper seal, and then the turn signal by re-tightening the mounting screw.

Finally, securely fasten the relay and take the positive power from the eyelet located just below the hood switch and the negative from the chassis ground. Complete the electrical connections as indicated in the installation diagram and properly arrange the wiring in the grommets until reaching the other headlight.

Finally, open the wiring cover near the brake fluid reservoir and intercept the red-white wire with yellow dots (+12 V ignition) to which you will connect the other wire from the wiring with a "tap": this will allow the LED ring to light up when the ignition is turned on. Then close the cover.

Optionally, you can also make an accessory connection to the red-green wire of the passenger side footwell light: this will allow the Angel Eyes to light up when the vehicle is unlocked with the remote.


Updated on 3 February 2026 by ScegliAuto


Related tutorials

BMW Serie 3 (1998-2006 / E46) To install the angel eyes bulbs on the BMW 3 Series, open the hood and remove the bolt located on the top of the headlight that contains the turn sig…
BMW Serie 3 (1998-2006 / E46) To install the ANGEL EYES bulb kit in the headlights, you must completely remove the front light assembly. Obtain the kit and start with the plastic …
BMW Serie 3 (2005-2013 / E92, E91, E90) The position light bulb for this car model, characterized by the so-called angel eyes appearance, is a special 12 Volt 6 watt bulb, with a unique sha…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

Other guides you may be interested in

Resetting the Tyre Pressure Monitoring System (TPMS) Light on the Toyota Yaris

These brief and simple steps will show you how to reset the tyre pressure monitoring system (TPMS) light on the Toyota Yaris. Before resetting the light, ensure that all four tyres are at the correct operating pressure. Get inside the vehicle on the driver's side and locate the TPMS reset button found at the bottom left of the dashboard (next to the steering wheel); press and hold it until the TPMS light on the instrument cluster resets, following the video until the end!

Watch the video!


by ScegliAuto

More videos