Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : Remove the bulb from the BMW E 90

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E92, E91, E90 - Years 2005-2013
Part: Headlight bulb
Operation: Remove the bulb from the BMW E 90

Remove the bulb of the Bme E 90? We remove the front side stone guard to access the light bulb compartment. We unscrew the plastic cover in the lower part of the mudguard with a screwdriver (plastic stone guard). We remove the plastic cover. We detach the lamp holder, remove the damaged bulb and mount a new one (same size and voltage). We carry out this replacement on the headlights to have the same type of lighting. We fasten the plastic trim under the front fender of the car with attached screws. We test the correct functioning of the lights: we turn on the instrument panel with the key and then we operate the control levers.


Posted on 21 December 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Serie 3 2005-2013 - What is the BMW 3 Series parking light bulb? Read Answer
    • Serie 3 2005-2013 - What are the position bulbs of the BMW E90? Read Answer
    • Serie 3 2005-2013 - How to remove the headlight bulb of a BMW 3 Series? Read Answer
    • Serie 3 1998-2006 - How to replace the headlight bulb on a BMW 3 Series? Read Answer
    • Serie 3 2005-2013 - Where is the position light in the BMW headlight? Read Answer

How to reset the service in the Opel Antara?

As we can see in this tutorial, resetting the service in the Opel Antara is an extremely simple and fast operation. Before proceeding, of course, we must have completed all the planned maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel, not the engine. At this point, we release the accelerator and press it 3 consecutive times, always all the way. We then restart the panel to verify that the procedure has been carried out correctly.

Watch the video!


by ScegliAuto

More videos