Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Front Headlight on BMW X3

Model: BMW X3 MK 1, E83 - Years 2003-2010
Part: Headlight

Start by removing the front wheel on the side of the headlight and lifting the vehicle. Once done, remove the cover under the hood: to do this, unscrew the numerous 8 mm screws that secure it and remove the round plastic clips. Move the wheel well cover and unscrew the T25 Torx screw located here. At this point, remove the front bumper on the side and disconnect the headlight connector. Unscrew the T30 Torx screws located above the front bumper and the cover here. Remove the front grille and then unscrew the headlight bolts.

Updated on 18 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the front headlight of the BMW X3
Replacement of the front headlight of the BMW X3
BMW X3 (2003-2010 / MK 1, E83) In this short guide, we will see the steps that will allow us to disassemble and replace the front headlight of the BMW X3. First, we open the hood o…
Replacing Front Headlight Bulb on BMW X3
BMW X3 (2003-2010 / MK 1, E83) Are the front headlight bulbs burnt out and need to be replaced? Let's see how to remove them on the X3 headlights. Open the hood by pulling the leve…
How to Remove the Rear Headlight of a BMW X3
How to Remove the Rear Headlight of a BMW X3
BMW X3 (2010-2017 / MK 2, F25) Before you can start, open the trunk lid of your BMW X3. Begin by prying off and removing the plastic cover near the rear headlight, exposing the bol…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos