Do it yourself
| ||||
|
BMW Serie 3 - Video tutorial
Model: BMW Serie 3
E46
- Years 1998-2006 In this video we will see the instructions on how to disassemble and replace the accelerator pedal of the Bmw 3 Series E46. First of all, let's get on board the car and equip ourselves with a thin flat screwdriver; then we go to press on the tab that we find on the side of the pedal, moving the pedal to the left to release it, as shown in the video. At this point we disconnect the electrical connector of the accelerator position sensor, thus removing the pedal; we just have to replace it with the new one and reassemble the new accelerator pedal correctly, following the video to the end!
Posted on 30 June 2022 by ScegliAuto
Other guides that may interest you |
Replace the steering angle sensor on the Volkswagen Golf 5When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.014
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |