Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Rear Light Assembly Removal Instructions

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Tail light

The rear light assembly consists of two parts: one fixed to the outer side of the body and the other attached to the hatch of the trunk. To remove the latter, open the trunk hatch and remove the underlying soundproofing cover. Once the cover is removed, disconnect the bulb holder to access the light assembly's mounting nut. Loosen this nut without completely removing it to release the retaining tab and free the light assembly first from the inside and then from the outside. Repeat the same steps for the other light assembly.

Updated on 15 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the rear lights of the BMW 3 Series
Replacement of the rear lights of the BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) In this guide, we will see the instructions that will allow us to disassemble and replace the rear lights of the trunk door of the BMW 3 Series. Firs…
How to Replace the Third Brake Light Bulbs on the BMW 3 Series
How to Replace the Third Brake Light Bulbs on the BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) Follow these instructions to remove and replace the bulbs and housing of the third brake light on the BMW 3 Series. First, open the trunk or access t…
How to disassemble the rear taillight of a BMW 328i xDrive
How to disassemble the rear taillight of a BMW 328i xDrive
BMW Serie 3 (2005-2013 / E91, E90, E92) Thanks to this useful video tutorial, we are shown how to disassemble the rear taillight of a BMW 328i xDrive, a specific model produced from 2009 to…

    Frequently Asked Questions

    • Serie 3 1990-2001 - How do you remove the brake light switch on the BMW 3 Series E36? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos