Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Stabilizer Bar Bushings

Model: BMW Serie 7 E68, E65, MK 4, E67, E66 - Years 2001-2008
Part: Bushings

This guide shows how to replace the bushings of the stabilizer bar. To facilitate removal, disconnect the bar. It is a very simple job; just disconnect the link at the end that is connected to the stabilizer bar and above the shock absorber. This gives you more room to pull the bar towards you and get the bushings closer for replacement. Since they need to be replaced, it is advisable to grease them well during reassembly to ensure they fit properly. If the procedure is performed correctly and carefully, the annoying noise from your car should be gone.

Updated on 22 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Automotive Bushings
Replacing Automotive Bushings
BMW Serie 7 (1994-2001 / MK 3, E38) If the bushings on your vehicle are worn, they need to be replaced, along with the control arms, suspensions, shock absorbers, sway bar links, etc. Y…
Replacing the Lower Torsion Bar
Replacing the Lower Torsion Bar
BMW Serie 7 (1994-2001 / MK 3, E38) If you need to replace the lower torsion bar due to the failure of its support ends, lift the vehicle on a lift and start by removing the nuts securi…
Car Creaking Problem
Car Creaking Problem
BMW Serie 7 (2001-2008 / E68, E65, MK 4, E67, E66) If your car creaks when turning or makes a squealing noise when you turn the steering wheel, there are several possible causes. The most likely cause…

How to Remove the Front Shock Absorber on a Peugeot 406

How to remove the front shock absorber on a Peugeot 406? The first step is to lift the bonnet and secure it with the prop rod. Use a socket wrench to unscrew the shock absorber mounting bolts (engine bay), lift the car on a column lift and remove the front wheel. Unscrew the shock absorber mounting bolts at the wheel hub (detach the brake line clips with a screwdriver). Unscrew the bolts on the side, then remove the shock absorber from its housing (place a support under the bar). Compare the old part with the new one and prepare for installation. Fit the new shock absorber to the car, working in reverse order.

Watch the video!


by ScegliAuto

More videos