Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the windshield washer pump in the BMW 5 Series?

Model: BMW Serie 5 E39 - Years 1995-2003
Part: Pump

In this tutorial, we can see how to replace the windshield washer pump in the BMW 5 Series, a very simple and quick operation. First of all, make sure the key is not inserted, then lift the front right side of the vehicle and remove the wheel. Next, locate the bolts in the lower inner area of the wheel arch, unscrew them with an 8mm socket wrench, and separate it from the frame. At this point, we will have gained access to the pump in question, which can be simply removed by pulling it upwards. To install the replacement and reassemble everything, just follow the reverse procedure.

Posted on 1 February 2024 by ScegliAuto

Video tutorial

Related tutorials

How to replace the windshield washer pump on the Series 5.
How to replace the windshield washer pump on the Series 5.
BMW Serie 5 (2003-2010 / E60, E61) If we want to proceed with replacing the windshield washer pump on this car model, in the following description we have gathered all the useful infor…
Replacing the windshield wiper pump on BMW 5 Series
Replacing the windshield wiper pump on BMW 5 Series
BMW Serie 5 (2003-2010 / E60, E61) Unscrew the three 8 mm bolts and only the 10 mm bolt in the left front wheel arch. All you need to do is to move the wheel arch just enough to access…
Replacement of the front windshield wipers of the BMW 5 Series.
Replacement of the front windshield wipers of the BMW 5 Series.
BMW Serie 5 (1995-2003 / E39) The following steps will show us the process of disassembly and replacement of the front windshield wipers, but it also applies to the rear wiper, of…

Other guides you may be interested in

How to Replace the Fan Resistor on a Renault Scenic

How to replace the fan resistor on a Renault Scenic. In this video, learn how to perform the disassembly: use a lever to remove the plastic under the glove compartment, and unscrew the cover (where the resistor is located) with a screwdriver. Disconnect the large connector of the resistor, then pull it out from the cabin. Insert a new fan resistor (connect the power connector). Finally, refit the cover and tighten the screws. Check the correct assembly of the previously fitted parts and test the correct operation of the fan.

Watch the video!


by ScegliAuto

More videos