Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Crankshaft Seal on the BMW 3 Series

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013

Today's tutorial will show you how to remove and replace the crankshaft seal on the BMW 3 Series, following the instructions below. First, open the hood and start by removing the serpentine belt, taking off the timing cover; then disconnect and remove the timing chain to access the crankshaft pulley, as shown in the video. At this point, remove its mounting bolts to take it off, then remove and replace the crankshaft seal, following the tutorial video to the end!

Updated on 12 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Crankshaft Pulley on BMW 3 Series
How to Remove the Crankshaft Pulley on BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) In today's video tutorial, see how to remove and replace the crankshaft pulley on the BMW 3 Series by following these simple and quick steps. First, …
How to Replace the Crankshaft Pulley on a BMW 3 Series?
How to Replace the Crankshaft Pulley on a BMW 3 Series?
BMW Serie 3 (2005-2013 / E91, E90, E92) To replace the crankshaft pulley on a BMW 3 Series, open the hood to access the components at the front of the engine block. For easier access, it ma…
How to Replace the Crankshaft Position Sensor on a BMW 3 Series?
How to Replace the Crankshaft Position Sensor on a BMW 3 Series?
BMW Serie 3 (2005-2013 / E91, E90, E92) To replace the crankshaft position sensor on a BMW 3 Series, open the hood to access the engine bay and unscrew the bolts securing various components…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos