Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Exterior Rearview Mirror of the BMW 3 Series

Model: BMW Serie 3 E92, E90, E91 - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Side mirror

See other generations:
Video tutorial

Follow these brief steps to remove and replace the exterior rearview mirror of the BMW 3 Series. First, open the driver's side front door and begin to remove the door panel by unscrewing all the fastening screws.

Then, unscrew the fastening screws of the mirror located on the inside, disconnect the electrical connector to pull it out and remove it, as shown in the video. At this point, install the new exterior rearview mirror, and finally adjust the glass, following the video tutorial to the end!


Updated on 2 October 2026 by ScegliAuto


Related tutorials

Removing and Replacing the Outside Rearview Mirror on the BMW 3 Series
Removing and Replacing the Outside Rearview Mirror on the BMW 3 Series
BMW Serie 3 (2012-2019 / F31, F30) This guide will show you how to remove and replace the outside rearview mirror on the BMW 3 Series. First, open the front door and start by removing …
Replacing the Glass of the Side Mirror on a BMW 3 Series
Replacing the Glass of the Side Mirror on a BMW 3 Series
BMW Serie 3 (2005-2013 / E92, E90, E91) Here are the instructions to remove and replace the glass of the side mirror on a BMW 3 Series. First, move to the outside of the vehicle and gently …
Removing and Replacing the Outer Mirror Cap of a BMW 3 Series
Removing and Replacing the Outer Mirror Cap of a BMW 3 Series
BMW Serie 3 (2012-2019 / F31, F30) In this brief guide, you will see the instructions to remove and replace the plastic cap of the outer mirror of the BMW 3 Series. First, get some pla…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos