Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Buick
    3. :
  3. Verano
    4. : How to replace the air conditioning fan motor and its filter on the Buick Verano Mk1

Buick Verano - Video tutorial

Model: Buick Verano MK 1 - Years 2010-2017
Part: Interior blower
Operation: How to replace the air conditioning fan motor and its filter on the Buick Verano Mk1

The guide shows how to replace the air conditioning fan motor and its filter on the Buick Verano Mk1. The first step is to disconnect the battery located in the engine compartment. From the front passenger compartment, with a 10 mm wrench, remove the lower part of the glovebox and disconnect the cable. Remove the plastic trim piece from the side edge of the dashboard. Remove the three T15 Torx screws from the bottom of the compartment; open the drawer, remove the four 7mm bolts in the corners of the drawer. Pull out the glove box and disconnect the interior lamp cable. From the bottom of the shoe compartment, remove the three air duct bolts, remove the two 10mm bolts holding the iron plate under the fan motor. Remove any remaining air ducts and disconnect the fan power cable. Remove the fixing screws of the fan and replace it with a new element. From the top of the fan, open the protective cover, remove the old filter and install the replacement. Reassemble everything in place and check the correct functioning of the fan.


Posted on 3 October 2022 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos