Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Buick
    3. :
  3. Enclave
    4. : How to change the battery on a Buick Enclave.

Buick Enclave - Video tutorial

Model: Buick Enclave MK 2 - Years 2018-2024
Part: Battery
Operation: How to change the battery on a Buick Enclave.

If we want to proceed in DIY mode to replace the battery on this car model, in the description immediately below we will find all the instructions and procedure to follow to carry out the replacement safely. In this car model, the battery is located under the floor in front of the rear seat. To access it, it is necessary to remove the plastic panel of the sliding guide of the rear seats and then proceed to unscrew the fixing screw of the panel placed on the floor. Under the panel we will find the battery and then proceed to remove the negative clamp first and then the positive one, then extract the battery from its housing to then position the new one and then reconnect the positive clamp first and then the negative one and finally close the panel.


Posted on 15 April 2023 by ScegliAuto

    Frequently Asked Questions

    • Enclave 2008-2017 - What causes the Buick Enclave battery problem? Read Answer
    • Enclave 2008-2017 - What's the problem with the Buick Enclave's battery? Read Answer
    • Enclave 2018-2025 - What are the symptoms of a dead battery on a Buick Enclave? Read Answer
    • Enclave 2018-2025 - What caused the Buick Enclave battery problem? Read Answer
    • Enclave 2008-2017 - What problems does the Buick Enclave battery have? Read Answer
    • Enclave 2008-2017 - What problems does the Buick Enclave battery have? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos