Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chevrolet
    3. :
  3. Spark
    4. : Light bulb

Chevrolet Spark - Light bulb

Chevrolet Spark (2009-2016 / MK 1, M300)
How to replace a Chevrolet Spark headlight indicator bulb
In this short guide we will see the instructions that will allow us to disassemble and replace the indicator bulb of the front light of the Chevrolet Spark, …read all…
Posted on 18 April 2023 by ScegliAuto
Chevrolet Spark (2009-2016 / MK 1, M300)
How to replace the rear light bulb on the Chevrolet Spark?
In order to replace the rear light bulb of the Chevrolet Spark, you need to open the tailgate of the luggage compartment and loosen the two bolts located on …read all…
Posted on 5 June 2022 by ScegliAuto
Loudspeaker (1) Antenna (1) Car stereo (2) Battery (2) Coil (1) Spark plugs (4) Key (4) Timing belt (2) -board computer (1) Checks and maintenance (4) Dashboard (1) Bearing (1) Headlight (2) Tail light (1) Air filter (1) Cabin air filter (1) Petrol filter (1) Oil filter (1) Clutch (1) Accessory Kit (1) Light bulb (2) Headlight bulb (4) Rear light bulb (1) Interior lights ceiling light bulb (1) Engine oil (1) Door panel (5) Brake pads (1) Gear Shift Knob (7) Fuel pump (3) Instrument cluster (2) Radiator (1) Fuse box (7) Outside rearview mirror (3) EGR valve (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos