Do it yourself
| ||||
|
Chevrolet Spark - Headlight bulb
Chevrolet Spark (2009-2016 / MK 1, M300)
How to install LED bulbs in the front headlights of a Chevrolet Spark In this video tutorial, we can see how it is possible to install LED bulbs (H4) in the front headlight of a Chevrolet Spark, following a few simple steps: the …read all… Posted on 17 July 2023 by ScegliAuto
Chevrolet Spark (2009-2016 / MK 1, M300)
How to replace the headlight bulbs in the Chevrolet Spark? In this tutorial we can see how to replace the headlight bulbs in the Chevrolet Spark, a very simple and fast operation. We start by making sure that the key …read all… Posted on 21 October 2022 by ScegliAuto
Chevrolet Spark (2009-2016 / MK 1, M300)
Replace the headlight bulb on the Chevrolet Spark Let's see in this short video how to remove and replace the headlight bulb on the 2013 Chevrolet Spark, in simple steps. First of all we open the bonnet of our …read all… Posted on 23 March 2024 by ScegliAuto
Chevrolet Spark (2009-2018 / )
Chevrolet Spark headlight replacement Is the Chevrolet Spark bulb damaged? Let's see the replacement of the bulb in the headlight. We open the bonnet by pulling the lever located at the bottom …read all… Posted on 24 December 2023 by ScegliAuto Loudspeaker (1) Antenna (1) Car stereo (2) Battery (2) Coil (1) Spark plugs (4) Key (4) Timing belt (2) -board computer (1) Checks and maintenance (5) Dashboard (1) Bearing (1) Headlight (2) Tail light (1) Air filter (1) Cabin air filter (1) Petrol filter (1) Oil filter (1) Clutch (1) Accessory Kit (1) Light bulb (2) Headlight bulb (4) Rear light bulb (1) Interior lights ceiling light bulb (1) Handle (1) Engine oil (1) Door panel (5) Brake pads (1) Gear Shift Knob (7) Fuel pump (3) Instrument cluster (2) Radiator (1) Fuse box (7) Outside rearview mirror (3) EGR valve (2) |
How to reset the service in the Opel Antara?As we can see in this tutorial, resetting the service in the Opel Antara is an extremely simple and fast operation. Before proceeding, of course, we must have completed all the planned maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel, not the engine. At this point, we release the accelerator and press it 3 consecutive times, always all the way. We then restart the panel to verify that the procedure has been carried out correctly. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.015
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |