Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Car Radio Speaker on the Rear Panel of the Chevrolet Beat

Model: Chevrolet Beat MK 1 - Years: 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021
Part: Speaker

Video tutorial

In this video, you will learn how to install the car radio speaker on the rear panel of the Chevrolet Beat. Open the trunk of the car and locate the two speakers under the plastic panels on either side of the vehicle. As shown in the video, each speaker is secured to its respective panel with four corner screws.

Take a Phillips screwdriver and start removing the screws. Before removing the speaker, make sure to disconnect the wire from its connector.

Once done, position the new speaker over the four screw holes and install it exactly like the previous one.


Updated on 3 July 2026 by ScegliAuto


Related tutorials

How to Replace the Cabin Filter on a Chevrolet Beat?
How to Replace the Cabin Filter on a Chevrolet Beat?
Chevrolet Beat (2010-2021 / MK 1) To replace the cabin filter on a Chevrolet Beat, open the glove compartment on the passenger side to fully detach it. After removal, you can access t…
How to Replace the Shock Absorbers on a Chevrolet Beat
How to Replace the Shock Absorbers on a Chevrolet Beat
Chevrolet Beat (2010-2021 / MK 1) To replace the shock absorbers on a Chevrolet Beat, lift the car with a jack or a lift so that the wheel corresponding to the shock absorber being re…
How to Replace the Cabin Air Filter in a Chevrolet Beat?
How to Replace the Cabin Air Filter in a Chevrolet Beat?
Chevrolet Beat (2010-2021 / MK 1) As you can see in this tutorial, replacing the cabin air filter in the Chevrolet Beat is a very simple and quick task. First, since it is located beh…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos