Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Lights on a Chrysler Voyager?

Model: Chrysler Voyager MK 4 - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007
Part: Light bulb

See other generations:
Video tutorial

To replace the rear lights on a Chrysler Voyager, use a lever tool to remove the securing clips accessible by opening the boot lid. There are two clips for each light: once these are removed, the light will detach from its housing, and to remove it completely, you will need to disconnect the connector.

The light will have a plastic plate on which all the bulbs are located: position, stop lights, etc. Simply remove them from their housing, replace them, and reinsert them along with the light.


Updated on 21 April 2026 by ScegliAuto


Related tutorials

How to Replace the Cabin Air Filter of a Chrysler Voyager
How to Replace the Cabin Air Filter of a Chrysler Voyager
Chrysler Voyager (2000-2007 / MK 4) Before you can start, open the front passenger door of your Chrysler Voyager. The cabin air filter is located beneath the glove compartment. First, u…
Where are the fuses located in the Chrysler Voyager?
Where are the fuses located in the Chrysler Voyager?
Chrysler Voyager (2020-2026 / MK 6) Any fuse in the Chrysler Voyager is located inside the only fuse box present in the vehicle: in this type of vehicle, you can find it inside the engi…
Where are the Fuses Located on a Chrysler Voyager?
Where are the Fuses Located on a Chrysler Voyager?
Chrysler Voyager (2000-2007 / MK 4) The fuse boxes on the Chrysler Voyager contain the fuses that regulate the operation of the devices installed on the vehicle: there is a single fuse …

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos