Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Driver's Side Headlight on a Chrysler Crossfire

Model: Chrysler Crossfire MK 1 - Years 2003-2007
Part: Headlight

Open the bonnet and insert the support rod. First, you need to remove the front bumper, so remove all the bolts and clips located in the two wheel arches that secure the bumper from underneath. Next, move to the top, where the screws securing the bumper near the bonnet are located. The grille is secured by two T25 Torx screws, while the two side screws near the headlights are T30. Unscrew them all, disconnect the headlight cables, and you can finally remove the bumper. Remove the two 8 mm bolts securing the headlight from underneath and the two bolts securing it from above.

Updated on 5 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Guide to Removing the Front Headlamps of the Chrysler Crossfire
Guide to Removing the Front Headlamps of the Chrysler Crossfire
Chrysler Crossfire (2003-2007 / MK 1) In this video tutorial, you will learn how to remove and replace the front headlamps of the Chrysler Crossfire, following the instructions below. Fir…
What is the Fuse Diagram for the Chrysler Crossfire?
What is the Fuse Diagram for the Chrysler Crossfire?
Chrysler Crossfire (2003-2007 / MK 1) In this video, you can see where the fuse boxes are located and their respective diagrams in the Chrysler Crossfire, useful if you need to check the …
How to Reset the Oil Change Light on the Chrysler Crossfire?
How to Reset the Oil Change Light on the Chrysler Crossfire?
Chrysler Crossfire (2003-2007 / MK 1) In the Chrysler Crossfire, as in many other models, after changing the engine oil, you need to manually reset the corresponding light. As shown in th…

Other guides you may be interested in

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos