Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. C4 Picasso
    4. : How to replace the cabin filter in the Citroen C4 Picasso?

Citroen C4 Picasso - Video tutorial

Model: Citroen C4 Picasso MK 2 - Years 2013-2022
Part: Cabin air filter
Operation: How to replace the cabin filter in the Citroen C4 Picasso?

Replacing the cabin filter in the Citroen C4 Picasso, as we can see in this tutorial, is an extremely simple and quick operation. First, go to the passenger side, then detach the outer partition of the dashboard and unscrew all the indicated screws using a Torx T20 key. Next, remove the lower panel of the center console, detach the partition of the glove compartment, and, by unscrewing the remaining Torx screws, separate it from the dashboard. At this point, open the long rectangular door, replace the filter, and reassemble everything following the reverse procedure.


Posted on 21 October 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • C4 Picasso 2013-2022 - Where is the cabin filter of the Citroen C4 Picasso? Read Answer
    • C4 Picasso 2013-2022 - Where is the Citroen C4 Grand Picasso pollen filter located? Read Answer
    • C4 Picasso 2006-2013 - Where is the cabin air filter of the 2007 Citroen C4 Picasso? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos