Do it yourself
| ||||
|
Citroen C3 - Video tutorial
Model: Citroen C3
FN, FC
- Years 2002-2009 To replace the gearbox oil of the Citroen C3, we start by opening the engine hood, remove the clamp holding the upper air pipe, disconnect the manifold near the just removed clamp, remove the air inlet duct by releasing it with a flathead screwdriver, unscrew the quarter turn that holds the air filter box, remove the air box by tilting it upwards and pulling it towards us; now we find the cap of the gearbox box manifold, remove it, insert a funnel with a tube into the hole of the gearbox box, pour transmission cleaner mixed with the used oil; once all the cleaner is poured, put the cap of the gearbox box back on, reposition the air box, attach it, reattach the air inlet pipe, reattach the clamp of the upper pipe with the manifold. Now we start the car engine, keep it running at idle for 10-15 minutes and then turn it off. Now we raise the front of the car, remove the lower protective cover in order to reach the oil drain plug of the gearbox box, with a special key, unscrew the oil drain plug while placing a large container underneath; replace the drain bolt with a new one, screw it in by hand and then continue with the key; now we lower the car, reassemble the air box with the pipes and the manifold, remove the oil filling cap again, insert the funnel with the tube, pour the exact amount of new oil, put the filling cap back on and finally reassemble the components of the air box.
Posted on 23 October 2023 by ScegliAuto
Other guides that may interest you
|
Frequently Asked QuestionsHandbrake adjustment on Ford EcosportFirst remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.087
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |