|
Do it yourself
| |||
| ||||
How to Change Oil and Filter on a Dacia Logan 1 Petrol?
Model: Dacia Logan
MK 1
- Years:
2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012
Video tutorial
In this video, you will see how to change the oil and filter on a Dacia Logan 1 petrol: in addition to the filter and new oil, it is also essential to purchase a new drain bolt and gasket. Unscrew the drain bolt and let the used oil drain into a suitable container: dispose of it along with the filter at an authorised centre. Before fitting the new filter, thoroughly clean the seating on the engine block where the gasket rests: even a grain of sand can cause a leak. Place the new gasket, lubricating it with a bit of clean oil, and then carefully tighten the filter. Now, refill the oil using a funnel to about 90% of the capacity, start the engine to fill the filter, and then check the level with the dipstick. Adjust it until it is just below the maximum, and your work is complete.
Posted on 21 May 2026 by ScegliAuto
Related tutorials
Dacia Logan
(2004-2012 /
MK 1)
To change the oil and filter on a Dacia Logan 1 petrol, follow this method: first, start the engine for a few minutes to thin the oil, then switch it…
Dacia Logan
(2004-2012 /
MK 1)
Replace the air filter on your Dacia Logan during the scheduled service at the required mileage. Open the car door, pull up the engine compartment re…
Dacia Logan
(2004-2012 /
MK 1)
To change the gear knob of your first series Dacia Logan, you just need to follow the procedure described in this new guide. The entire operation tak…
Other guides you may be interested in
|
How to Remove the Rear Seat of a Hyundai Tucson?
To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.034
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |