Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Battery on a Datsun Redi Go

Model: Datsun Go MK 1 - Years: 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022
Part: Battery

Video tutorial

This guide shows how to replace the battery on the Datsun Go, including the Go+ and Redi Go models. First, secure the vehicle and open the hood using the lever located at the bottom of the dashboard.

Use a 10 mm wrench to unscrew the bolts securing the electrical connectors; disconnect the negative terminal first, then the positive, being careful not to let them touch any metal parts. Now, unscrew the two bolts of the battery bracket and remove the old battery.

Install the new battery and check that the vehicle starts correctly; it may take a few minutes for the car to start as the circuit may be completely drained; in that case, wait a few minutes and try again.


Updated on 15 July 2026 by ScegliAuto


Related tutorials

How to Remove the Dashboard of the Datsun Redi Go
How to Remove the Dashboard of the Datsun Redi Go
Datsun Go (2013-2022 / MK 1) In today's video, you will see how to completely remove the dashboard of the Datsun Redi Go. First, remove the center steering wheel cushion. Then, l…
How to Replace the Air Filter on the Datsun Redi Go
How to Replace the Air Filter on the Datsun Redi Go
Datsun Go (2013-2022 / MK 1) To replace the air filter on the vehicle, proceed as follows: Open the hood; roughly in the center of the engine compartment, at the front, is the bo…
How to Top Up the Coolant in the Datsun Redi Go
How to Top Up the Coolant in the Datsun Redi Go
Datsun Go (2013-2022 / MK 1) If the reservoir containing the radiator coolant has a low or nonexistent fluid level, you need to refill it as soon as possible. To complete the ent…

How to Activate the Disabled TRC on the Toyota Yaris?

As the video clearly shows, disabling or activating the traction control (TRC or ESP) on the Toyota Yaris is very simple. By default, the traction system activates every time the vehicle is started. To disable it, simply press the button depicting a skidding car located in the centre of the vehicle where the controls are, such as the hazard lights and the radio, but near the handbrake. Once disabled, the TRC off light will illuminate on the dashboard. To reactivate it, just press the same button again.

Watch the video!


by ScegliAuto

More videos