Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the exhaust pipe of the Derbi GPR 50?

Model: Derbi Gpr 50
Part: Exhaust muffler

Video tutorial

To replace the exhaust pipe on the Derbi GPR 50, you need to loosen the screws that secure the exhaust terminal to the appropriate supports, located near the rear wheel on the right side of the motorcycle: once the supports have been loosened, you can widen the ring between the exhaust pipe and the collector.

The exhaust terminal can then be removed from its seat to insert the new one: this can now be connected with the connecting clamp and secured to the supports with the appropriate screws just removed.


Posted on 22 November 2025 by ScegliAuto


Related tutorials

How to Replace the Exhaust on a Derbi GPR 50?
How to Replace the Exhaust on a Derbi GPR 50?
Gpr 50 To replace the exhaust on the Derbi GPR 50, loosen the screws that secure the exhaust end can to the supports. Once the old exhaust is freed from its…
How do you replace the stator of the Derbi GPR 50?
How do you replace the stator of the Derbi GPR 50?
Gpr 50 To replace the stator of the Derbi GPR 50, you will need to loosen the screws that secure the cover of the component, which will be located on the le…
How to Replace the Cylinder Head Gasket on a Derbi GPR 50?
How to Replace the Cylinder Head Gasket on a Derbi GPR 50?
Gpr 50 To replace the cylinder head gasket on a Derbi GPR 50, loosen the bolts securing the cylinder to the top of the engine block, removing the coil and t…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos