Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Cylinder Head Gasket on a Derbi GPR 50?

Model: Derbi Gpr 50
Part: Checks and maintenance

Video tutorial

To replace the cylinder head gasket on a Derbi GPR 50, loosen the bolts securing the cylinder to the top of the engine block, removing the coil and the corresponding spark plug. Once the bolts are loosened, disconnect the various connectors and remove the cylinder.

After removal, locate the underlying head gasket, which can be taken out from its seat and replaced with a new one. After the replacement, reposition the cylinder, securing it properly along with all the other components.


Updated on 13 September 2026 by ScegliAuto


Related tutorials

How do you disassemble the engine of the Derbi GPR 50?
How do you disassemble the engine of the Derbi GPR 50?
Gpr 50 It will be possible to disassemble the engine of the Derbi GPR 50 by loosening the screws that fix it to its housing: this will be located in the low…
How to Dismantle the Engine of the Derbi GPR 50?
How to Dismantle the Engine of the Derbi GPR 50?
Gpr 50 The procedure for dismantling the engine block of the Derbi GPR 50 involves loosening the screws that secure the engine cylinder to its housing, allo…
How do you replace the stator of the Derbi GPR 50?
How do you replace the stator of the Derbi GPR 50?
Gpr 50 To replace the stator of the Derbi GPR 50, you will need to loosen the screws that secure the cover of the component, which will be located on the le…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos