Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Flywheel and Stator on a Derbi GPR 50

Model: Derbi Gpr 50
Part:

Video tutorial

In this video tutorial, you will learn how to remove the flywheel and stator on a Derbi GPR 50cc in simple steps. First, remove the left side cover to access the flywheel and chain sprocket; then, obtain a puller to remove the flywheel by unscrewing the central bolt, as shown in the video.

Next, unscrew the screws of the stator plate and disconnect the electrical wires to remove it; now you can also replace the fly seal on the flywheel side. Reassemble everything by applying the reverse procedure!


Updated on 8 April 2026 by ScegliAuto


Related tutorials

How do you replace the stator of the Derbi GPR 50?
How do you replace the stator of the Derbi GPR 50?
Gpr 50 To replace the stator of the Derbi GPR 50, you will need to loosen the screws that secure the cover of the component, which will be located on the le…
Dismantling the Clutch on a Derbi GPR 50
Dismantling the Clutch on a Derbi GPR 50
Gpr 50 In today's video tutorial, you will see how to dismantle and replace the clutch in simple steps on a Derbi GPR 50, but also on an Aprilia RS 50. Firs…
Replacing Rear Brake Pads on a Derbi GPR 50
Replacing Rear Brake Pads on a Derbi GPR 50
Gpr 50 In today’s video, we will see the steps to remove and replace the rear brake pads on a Derbi GPR 50 motorcycle. First, unscrew the mounting bolts of …

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos