Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Dismantling the Clutch on a Derbi GPR 50

Model: Derbi Gpr 50
Part: Clutch

Video tutorial

In today's video tutorial, you will see how to dismantle and replace the clutch in simple steps on a Derbi GPR 50, but also on an Aprilia RS 50. First, remove the side cover of the clutch, which is located on the right; to do this, remove the water pump pipe, allowing the coolant to drain, and unscrew the bolts of the cover, disconnecting the clutch cable.

At this point, unscrew the central screws of the clutch pack to remove the inner discs; simply replace them with the new ones of the correct type, following the video tutorial until the end!


Updated on 27 April 2026 by ScegliAuto


Related tutorials

Removing the Flywheel and Stator on a Derbi GPR 50
Removing the Flywheel and Stator on a Derbi GPR 50
Gpr 50 In this video tutorial, you will learn how to remove the flywheel and stator on a Derbi GPR 50cc in simple steps. First, remove the left side cover t…
How to Dismantle the Engine of the Derbi GPR 50?
How to Dismantle the Engine of the Derbi GPR 50?
Gpr 50 The procedure for dismantling the engine block of the Derbi GPR 50 involves loosening the screws that secure the engine cylinder to its housing, allo…
How do you replace the stator of the Derbi GPR 50?
How do you replace the stator of the Derbi GPR 50?
Gpr 50 To replace the stator of the Derbi GPR 50, you will need to loosen the screws that secure the cover of the component, which will be located on the le…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos