Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Ducati 749 - Videoguide

Ducati 749
How do you change the engine oil on a Ducati 749S?
In order to replace the engine oil on the Ducati 749S, you need to unscrew the oil tank drain plug, which is located in the lower central part of the bike: …read all…
Posted on 30 April 2023 by ScegliAuto
Ducati 749
Replacement of the air filter on Ducati 749 and 999
Replacing the air filter on Ducati 999 or 749 is extremely simple and now we will show you. Yes, because to open the filter box all you have to do is unscrew …read all…
Posted on 1 February 2024 by ScegliAuto
Ducati 749
Oil change and brake bleeding on Ducati 749
As shown in the video, start by unscrewing the cap and removing the upper membrane. If you have a syringe, suck the brake fluid from above until the reservoir …read all…
Posted on 26 January 2024 by ScegliAuto
Ducati 749
Replacement of spark plugs on Ducati 749
Disconnect the coil connector by pressing on the tab and pulling it off. Unscrew the 10 mm nut, without losing it, and lift the spark plug cap using some …read all…
Posted on 8 November 2023 by ScegliAuto
Ducati 749
Replacement front brake pads Ducati 999-749
In this video tutorial we will see how to remove and replace, in simple steps, the front brake pads on a Ducati 999 and 749. First of all, let's loosen the two …read all…
Posted on 8 January 2024 by ScegliAuto
Spark plugs (1) Air filter (1) Brake oil (1) Engine oil (1)

See also:

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos