Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Ducati 999
Part:

After cleaning it, fit the steering plate ensuring the holes align with the handlebar pins and screw it in place. To identify the right and left forks, simply observe where the bolts for the caliper will be inserted. Before fitting them, grease the two bolts of the lower plate, as shown in the video. Insert the fork from underneath into the upper plate and lightly screw all the screws (lower and upper plate). After fitting the second fork and ensuring the pin is properly seated, tighten the bolts to the torque specified in the video.

Updated on 8 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the headlight bulb in the Ducati 999?
How to replace the headlight bulb in the Ducati 999?
999 In this tutorial we can see how to replace the headlight bulb in the Ducati 999, an extremely simple and quick operation. First of all, make sure tha…
How do you replace the rear brake pads of the Ducati 999?
How do you replace the rear brake pads of the Ducati 999?
999 In order to replace the rear brake pads of the Ducati 999, you need to loosen the screws that secure the rear brake caliper to the corresponding disc…
How to replace the control unit of the Ducati 999/749
How to replace the control unit of the Ducati 999/749
999 Today we will see, in this video tutorial, how to remove and replace the engine control unit of the Ducati 999, but also of the 749. First of all, le…

Replacing Brake Fluid on Aprilia RS 125

As always, secure your Aprilia RS 125 in a stable and safe position to work on it, ensuring the operator's safety as much as possible. It is advisable to take this precaution every time you perform maintenance on any motorcycle. Now, connect a suitably sized hose to the bleed valve (located on the brake system component at the front wheel). The other end of the hose should drain into a container you have prepared in advance. At this point, pump the old fluid out of the brake circuit into the container by repeatedly squeezing the brake lever. Be careful not to allow air to remain in the circuit by closing the valve before expelling all the fluid. Finally, after closing the valve, simply introduce the new fluid into the circuit. And that's it!

Watch the video!


by ScegliAuto

More videos