Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Here is the guide on how to perform routine maintenance by replacing the engine oil and oil filter on a Ducati Multistrada 1260 Enduro. First, remove the lower engine guard by unscrewing the fastening screws; then remove the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes. At this point, use the appropriate tool to unscrew the oil filter; replace it with a new one, lubricating the seal, and screw it in hand-tight. Finally, pour in the new engine oil!

Updated on 5 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the rear wheel of the Ducati Multistrada 1260 Enduro
How to replace the rear wheel of the Ducati Multistrada 1260 Enduro
Multistrada 1260 The information provided in this guide will show us how to disassemble and replace the rear wheel or tire of the Ducati Multistrada 1260 enduro motor…
How to Remove the Front Wheel on the Ducati Multistrada 1260 Enduro
How to Remove the Front Wheel on the Ducati Multistrada 1260 Enduro
Multistrada 1260 In today's video, you will see the steps to remove and replace the front wheel on the Ducati Multistrada 1260 Enduro. First, position the bike on a s…
How to replace the cooling liquid of the Ducati Multistrada 1260
How to replace the cooling liquid of the Ducati Multistrada 1260
Multistrada 1260 Today we will see step by step instructions on how to replace the engine coolant of the Ducati Multistrada 1260. First of all, we put the motorcycle …

How to Replace the Air Filter on a Honda XL1000 Varadero?

In this tutorial, you will see how to replace the air filter on a Honda XL1000 Varadero, a very simple operation. First, remove the seat, then unscrew the two rear mounting bolts of the tank, the two front ones, and the remaining ones located on the sides. Once done, close the two fuel taps, disconnect the rubber hose, and lift the tank. At this point, you will have access to the filter box, which can be opened by removing the 8 screws around the perimeter. Once the filter is replaced, reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos