Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this tutorial, you will see how to reset the ECU on the Royal Enfield Classic 350, a very simple and quick operation, for example, to clear a fault indication. Before proceeding, ensure you have resolved the issue causing the warning light to illuminate. Start by inserting the key but leave it in the initial position, then fully open the throttle and turn on the instrument cluster, not the engine. Once done, wait for the warning light to stop flashing, turn off the cluster, release the throttle, and start the bike.

Updated on 12 September 2026 by ScegliAuto

Video tutorial

Related tutorials

Where to Find the Fuses on a Royal Enfield Classic 350
Where to Find the Fuses on a Royal Enfield Classic 350
Classic 350 In this guide for Royal Enfield Classic 350 owners, we will discover where all the various fuses are located. First, ensure the motorcycle is complet…
How to Reset the Service Light on a Royal Enfield Classic 350
How to Reset the Service Light on a Royal Enfield Classic 350
Classic 350 Today, discover the steps to reset the service light for the regular maintenance oil change on the Royal Enfield Classic 350 motorcycle. First, place…
How to Replace the Headlamp Bulb on the Royal Enfield Classic 350
How to Replace the Headlamp Bulb on the Royal Enfield Classic 350
Classic 350 To replace the headlamp bulb on the Royal Enfield Classic 350, loosen the screws around the perimeter of the headlamp so that it can be released from…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos