|
Do it yourself
| |||
| ||||
How to Remove the Rear Wiper Arm on a Fiat 500
Model: Fiat 500
500 X
- Years 2014-2022
The selected video demonstrates not only how to remove the rear wiper arm but also how to mask the mechanism. The first step in mounting the motor is to remove the rear wiper arm. To do this, lift the plastic cover on the pivot of the wiper arm and unscrew the bolt that secures it to the hinge using the appropriate spanner. At this point, pull the entire wiper arm off. To mask the hole, open the tailgate and, after unscrewing the screw that secures the handle and removing the 4 clips, take off the inner panel. Using the appropriate spanner, unscrew the 3 bolts that secure the motor and speed regulator, and then remove them (after disconnecting the electrical supply, which can be secured with a plastic tie). Now remove the internal plastic cover near the hinges of the tailgate to access and disconnect the washer pump, and after sealing it with a suitable cap, reassemble everything. Fit the rubber seals and the plastic cap in the wiper pivot hole. Finally, refit the inner panel of the tailgate by following the reverse of the instructions shown in the images.
Updated on 1 March 2026 by ScegliAuto
Video tutorial
Related tutorials
Fiat 500
(2007-2024 /
312)
In this guide, we will see the instructions that will allow us to disassemble and replace the rear windshield wiper or rear wiper of the Fiat 500, in…
Fiat 500
(2007-2024 /
312)
Below we will discover the steps that will allow us to disassemble and replace the rear windshield wiper or rear wiper of the Fiat 500. First, move t…
Fiat 500
(2007-2023 /
)
Today we will see how to disassemble and replace the rear windshield wiper of the Fiat 500, following the instructions below. First of all, move to t…
Other guides you may be interested in
|
Frequently Asked QuestionsHow to Bleed the Clutch on a Renault Clio?
To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.131
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |