Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Panda
    4. : How to remove the fog light of a Fiat Panda

Fiat Panda - Video tutorial

Model: Fiat Panda MK 2, 169 - Years 2003-2012
Part: Fog lights
Operation: How to remove the fog light of a Fiat Panda

Let's see how to remove the fog light with attached bulb on Fiat Panda. Let's get ready to disassemble the side fog light placed in the bumper: with a special screwdriver unscrew the fastening screw of the plastic of the spotlight (placed on the sides of the plastic), then, remove the same from the bumper with a lever. Unscrew the screws of the spotlight (screw in the lower part of the bumper) and detach it from the side plastic (disconnect the power connector). We assemble the new piece with a new bulb attached (same size and voltage). We test the correct functioning of the same after assembly.


Posted on 12 November 2023 by ScegliAuto

    Frequently Asked Questions

    • Panda 2003-2012 - Where are the fog lights located in the Fiat Panda? Read Answer
    • Panda 2003-2012 - How do you replace the fog lights on the Fiat Panda? Read Answer
    • Panda 2012-2023 - How much do the fog lights (assembly included) cost on a 2020 Fiat Panda Easy? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos