Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Panda
    4. : How to replace the front fog light bulb of the Fiat Panda.

Fiat Panda - Video tutorial

Model: Fiat Panda MK 3, 319 - Years 2012-2023
Part: Fog lights
Operation: How to replace the front fog light bulb of the Fiat Panda.

Today's guide will show us the steps on how to disassemble and replace the front fog light bulb of the Fiat Panda, following the instructions below. In order to access the fog light bulb, it will be necessary to access it from the front wheel arch; therefore, we remove the plastic partition and disconnect the fog light bulb electrical connector, as shown in the video. At this point, we install the new bulb, replacing the entire headlight if necessary; we make the electrical connection and check the functioning of the light before reassembling everything!


Posted on 31 August 2023 by ScegliAuto

    Frequently Asked Questions

    • Panda 2003-2012 - Where are the fog lights located in the Fiat Panda? Read Answer
    • Panda 2003-2012 - How do you replace the fog lights on the Fiat Panda? Read Answer
    • Panda 2012-2023 - How much do the fog lights (assembly included) cost on a 2020 Fiat Panda Easy? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos