Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Light of a Fiat Panda 4x4

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Tail light

To replace the rear light unit of a Fiat Panda 4x4, position the vehicle on a stable and secure surface, either on a ramp or flat ground. Open the tailgate of the boot and proceed to unscrew the three screws located near the inner perimeter of the light unit you intend to remove. Now, pull the unit from its housing to release the three clips that hold it in place (be careful not to apply too much force to avoid damaging the electrical connection wires). At this point, if you need to replace a bulb, you can also remove the cover that houses them. Simply unscrew the four screws (as indicated in the video) and you're done! Proceed to replace the bulb of your choice (press and turn counter-clockwise) and reassemble everything.

Updated on 27 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Fuel Pump on a Fiat Panda 4x4 (169)
How to Remove the Fuel Pump on a Fiat Panda 4x4 (169)
Fiat Panda (2003-2012 / 169, MK 2) In this tutorial, you will learn how to remove and replace the fuel pump or low-pressure fuel sender on a Fiat Panda 4x4 (169). First, open the rear …
How to Dismantle the Rear Wiper Motor of the Fiat Panda 4x4 (141)
How to Dismantle the Rear Wiper Motor of the Fiat Panda 4x4 (141)
Fiat Panda (1980-2003 / 141, MK 1) In this video, you will see the steps that will allow you to dismantle and replace the rear wiper motor of the first series Fiat Panda 4x4, version 1…
How to Remove the Drive Shaft from a Fiat Panda 4x4
How to Remove the Drive Shaft from a Fiat Panda 4x4
Fiat Panda (2003-2012 / 169, MK 2) In this guide, learn how to dismantle the drive shaft and replace the oil seal on a Fiat Panda 4x4. First, raise the vehicle and start unscrewing all…

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos