Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Dismantle the Rear Wiper Motor of the Fiat Panda 4x4 (141)

Model: Fiat Panda MK 1, 141 - Years: 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991

See other generations:
Video tutorial

In this video, you will see the steps that will allow you to dismantle and replace the rear wiper motor of the first series Fiat Panda 4x4, version 141. First, open the tailgate and start by unscrewing the screw of the wiper motor, disconnecting its electrical connector; remove the rear wiper from the outside.

At this point, replace the entire piece of the motor, positioning it in place and then securing it with the relevant screws; finally, connect the electrical cable and fit the new wiper!


Updated on 3 June 2026 by ScegliAuto


Related tutorials

Replacing the Rear Wheel Bearing on the Fiat Panda 4x4
Replacing the Rear Wheel Bearing on the Fiat Panda 4x4
Fiat Panda (1980-2003 / MK 1, 141) In today's tutorial, you will learn how to remove and replace the rear wheel bearing on the Fiat Panda 4x4 by following these simple and quick steps.…
How to replace the rear differential silent blocks on the Fiat Panda 4x4?
How to replace the rear differential silent blocks on the Fiat Panda 4x4?
Fiat Panda (2003-2012 / 169, MK 2) To replace the rear differential silent blocks on the Fiat Panda 4x4, first loosen the bolt and nut securing the stabiliser bar at the rear. Once the…
Replacing the Gear Gaiter on the Fiat Panda 4x4
Replacing the Gear Gaiter on the Fiat Panda 4x4
Fiat Panda (1980-2003 / MK 1, 141) In today's video tutorial, we will cover the main instructions for dismantling and replacing the gear gaiter on the Fiat Panda 4x4. First, lift the v…

    Frequently Asked Questions

    • Panda 2003-2012 - Where is the fuel filter located on the Fiat Panda 1.2 169? Read answer

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos